Tesla Model 3 Rear Bumper Replacement [Guide For Model S,3,X,Y]

There may be a moment when you need to remove the bumpers, whether installing a hitch or wrapping vinyl around the edges. Okay, so that might not occur frequently, but it could. Any bumper removal could be a difficult procedure for a novice. I developed this method to Tesla Model 3 Rear Bumper Replacement securely and effectively.

Tesla Model 3 Rear Bumper Replacement

Tools You Need

• The 8mm socket
• Ten mm socket
• 8mm short hex wrench
• The ratchet
• Torx T25 Screw
• Flathead screwdrivers or pry bars
• The gloves
• Frog or painter’s tape

Preparation

You will need to remove numerous bolts underneath your Tesla, so jacking it up (as we did in the video) will be helpful.

But you can accomplish this without a jack. To raise it, be careful to utilize jack pads. If you don’t, you could seriously harm your undercarriage.

Normally, we use two layers to protect the surface when removing the bumper.

Tail Light Removal

1. Take off the bolt holding the tail lights in place. Just remove the screw.
2. Remove the bottom and side weather seals.
3. Take out the trunk’s plastic component. There are 4 clips in total.
4. To remove the tail light connector from the trunk, pull back the liner behind the location of the taillights. To disconnect, you must first press the red clip up and then gently wiggle it.
5. A stubby wrench can unbolt The two 8mm bolts.
6. Take remove the taillights. Try to pull out straight to prevent severing the side rails from the tail lights.

Clips And Bolts Removal

1. Take off the three clips from either side of the wheel well. Push the pin up and pull it out using a prying or trim removal tool. On both sides, execute.
2. Take out the T25 Torx Screw from each side of the wheel well. When you remove this screw, it can drop into the bumper region. After removing the bumper, grip it.
3. Using a pry tool, unsnap the two clips concealing the bolts at the bumper’s edge.
4. Take out the seven 10mm bolts securing the undercarriage. To determine which ones you need to eliminate, watch the video.
5. Take off the two 10mm bolts covering the motor. Although it’s not required, reinstalling the bumper afterward will make it easier.
6. Take off the two 10mm bolts attached to the top of the bumper, where the taillights once were.

Bumper Removal

• Pull the bumper until the clips holding it in place are released, starting from the sides. It’s best to switch between sides frequently.
• When you reach the center, carefully pull while holding the bumper in place with your knee or a little stool underneath to prevent it from falling.
• Once it has been taken out, be sure to cut the sensor cables. To disconnect it, merely slide the red tab out and push the black pin. On the right side, this is where it is.
• That concludes it. You’ve effectively taken off your back bumper!

Tips & Tricks When Reinstalling The Rear Bumper

• Reinstall it in the opposite sequence from when you took it out.
• When realigning, start in the middle. This will guarantee that everything fits together.

Tesla Bumper Replacement Cost

It becomes important to replace your Tesla’s front or back bumpers when damaged.

You may need to spend some money at a Tesla Service Center or an auto shop for the basic replacement, depending on the extent of the problematic part’s damage.

If your warranty is explained, remember that the replacement cost at the auto shop will be lower than at the Tesla Service Center.

They could charge a maximum of $2,000 or $1,000. Additionally, if the work is very specialized, you will pay more.

The cost can vary across all series because the replacement of the bumper depends on so many different factors.

Let me demonstrate the front and rear Tesla bumper replacement prices from the Tesla Service Center:

• The front and rear bumpers for the Tesla Model 3 can set you back anywhere from $2,375 to $3,100 or more. The cost of replacing the Tesla bumper will be $3,500 or near that, although the labor may seem to take a while.
• For the Tesla Model Y, the front and rear bumper replacement will cost between $3,670 and $3,900, or roughly that much.
• The Tesla Model X bumper costs more money. In this situation, you’ll need to spend between $2,800 to $4,500 (front + rear).

Why are The Tesla Model S’s front and rear bumper replacement costs lower than competitors? Depending on the other factors, the price will range from $2,200 to $2,400.

How Can Tesla Bumper Be Repaired?

It is recommended to use the do-it-yourself method rather than shell out thousands of dollars for repair if the bumper of the Tesla exhibits some significant scratches, scuffs, or white spots.

To achieve that, adhere to the guidelines provided:

• Examine all bumper dings on the front and back.
• To wipe both bumpers, spritz some glass cleaner onto a soft cloth.
• To remove any extra, wipe it off with tissue paper.
• Use masking tape to cover the top and bottom surfaces so that nothing but the front and back bumpers are visible.
• After determining the correct color of the bumper, get a matching paint repair kit from Tesla.
• The repair package will include the microfiber cloth, brushes, and other supplies.
• Use the cloth to clean the bumper.
• Shake the color and dab onto the scratches with the brush. Wearing gloves first, smear the color with your hand after applying it.
• Hold off for 5 minutes.
• Apply the blending solution, then wipe the surface with the provided cleaning cloth.
• Use a microfiber cloth to clean the surface. Reapply the paint over any scratches that aren’t covered, then wait another five minutes.
• Repeat the process for the additional scuffs on the front and rear bumpers.
• Done!

Reason Why Tesla Bumper Replacement Cost So Much?

You could be concerned about the hefty cost, as we just discussed how much you must pay for a Tesla bumper.

Although the cost to repair the item is significant, doing so requires much work and sophisticated machinery. Additionally, the Model X Tesla replacement cost is greater.

The cost of producing Tesla parts is more than for other automobile models. The bumper’s price goes up because it is an OEM component.

The bumper consequently becomes more expensive every year. On the other hand, the supply of the components for Tesla is another factor that influences the price of the bumper.

You may occasionally be unable to purchase Tesla bumpers at the going pricing due to a scarcity of supply.

In this case, the increased rate will force you to pay more for the replacement job.

You will undoubtedly discover that you need to spend more on Tesla if you compare it to a Toyota Corolla, which will cost between $800 and $1400 to replace the bumper.

The Honda Accord is no different. You must pay between $130 and $1300 for the bumper.

Therefore, the Tesla bumper’s manufacturing cost is considerable compared to all. Additionally, the availability needs to be improved. For this reason, you pay more for it!

We also need to maintain sight of the fact that Tesla is a luxury brand. Unfortunately, it would help if you accepted the strain on your wallet when carrying such a brand.

Cost To Install A Bumper In Tesla

The price for the brand-new Tesla bumper and the total cost of the replacement has been considered.

However, we can also assist you if you want to know the installation cost. You’ll pay $400 to $1,200 or more to paint and install a new bumper.

The cost depends on the repair facility, the extent of the damage, and the particular model being used. By looking at the complete pricing, you can determine which model will cost how much money.

Conclusion

Sometimes, Tesla Model 3 Rear Bumper Replacement is important. To be safer on the roadways, all you need to do is invest enough.

The greatest thing you can do to prevent accident damage is regularly check your bumpers and attempt to ride on smooth roads.

The journey will be too long to live if your Tesla’s bumpers aren’t functioning, so check them frequently!

Frequently Asked Questions